New AutoTuner Protocol Update!
The OBD protocol of the Bosch MD1CS004 ECU for 2.0L TDI VAG engines benefits from new improvements. 🔥
🎉 About the H80 hardware: some versions can be handled in OBD mode, as this method uses an approach specific to the VAG manufacturer. However, the BENCH method relies on a specific Bosch service mode, directly tied to the ECU. Therefore, an H80 ECU cannot be handled in BENCH mode, but might be handled in OBD mode. Learn More At Ai Remap
✅ Better coverage: The protocol now supports a greater number of Cboot versions. As a result, new VR files have been added and several corrections have been made for even more complete coverage.
We have also developed a better detection for VAG group ECUs, which allows you to know right from the identification if your ECU is supported.
New versions of some ECU references have been introduced by VAG. Those are not yet supported and are identified as Gen2 (for example: MD1CS004 Gen2).
Stay tuned to discover our upcoming news! 🔥
Key Features
- Type: Engine Control Unit (ECU) ⚙️
- Readout: OBD VR 🔌
- MCU:TC298 🖥️
- Write time with unlocking: 6min ⏱️
- Write time once unlocked: 2min ⏱️
- Checksums correction ✅
- Back to stock function 🔄
Compatibility List
AUDI: 2.0 TDI CR EU6 / 30 TDI (2.0) / 40 TDI (2.0)
CUPRA: 2.0 TDI CR EU6
FORD: 2.0 EcoBlue
SEAT: 2.0 TDI CR EU6 / 2.0 TDI CR EU6.2
SKODA: 2.0 TDI CR EU6 / 2.0 TDI CR EU6.2
VOLKSWAGEN: 2.0 TDI CR EU6 / 2.0 TDI CR EU6.2 / 2.0 TDI GTD
The List Of Vehicles May Evolve Over Time.
